ENGINE O/H KIT STD | KUBOTA 03 SERIE V3800-DI-E2B/V3800-DI-E3B DIRECT INJECT | KV3800DI

(4) Piston & Ring Kit

(5) Main Bearings

(1) Front Crankshaft Bushing

(4) Connecting Rod Bearings

(1) Front Crankshaft Seal

(1) Rear Crankshaft Seal

(1) Thrust Washer

(1) Head Gasket Set *Head Gasket Sold Separately (see related products below)

(1) Lower Gasket Set

(4) Piston Pin Bushing

Which head gasket you require, you will need to measure the distance from top-most face of each piston to the upper surface of the cylinder head. In order to obtain an accurate reading, Heavy Duty Pros recommends measuring this distance using 4 spots around the perimeter of each piston with a dial gauge in order to determining the "Average" protrusion or recession per piston.  

2 Notch (Thinnest) - 0.90 mm thickness before tightening, 0.80 mm after tightening. To be used with Piston Recession of -0.07 mm to a Protrusion of  +0.049 mm 

1 Notch (Mid) - 1.00 mm thickness before tightening, 0.90 mm after tightening. To be used with Piston Protrusion of +0.050 mm to +0.149 mm

No Notch (Thickest) - 1.05 mm thickness before tightening, 0.95 mm after tightening. To be used with Piston Protrusion of +0.150 mm to +0.20 mm

EQUIPMENT MODELS